Riding Your Snowmobile

Inspecting Your Snowmobile Before You Ride: START-GO

Always inspect your snowmobile before each ride to detect problems that could cause an accident.

• Always set the parking brake first.
• Consult your owner’s manual for items that may need to be lubricated, tightened, adjusted, aligned, or checked for wear. An easy way to remember the items to inspect is the phrase “START-GO.”

• Steering, Skis, and Drive System
  • For the steering system, verify that handlebars turn smoothly.
  • Make sure skis are in good shape and free from ice.
  • Check that the drive belt is in good shape and tight.
• Throttle and Brake
  • Press levers—they should move easily and snap back.
  • Check that cables are in good shape with tight connections.
• Activate Lights
  • Turn on the lights.
  • Press the brake, and have your riding partner make sure the brake light illuminates.
  • Remove any ice, snow, and dirt from your lights, instruments, mirrors, and windshield.
• Registration and Reflectors
  • Make sure that your registration is current.
  • Check that reflectors are attached and clean.
• Track and Suspension
  • Make sure that the track is in good shape. Studs and paddles should be tight.
  • Be sure that the suspension is functioning well.
• Gasoline and Oil
  • Make sure the tank is full of fresh gas.
  • Check oil while the engine is off.
  • Check for fuel or oil leaks.
• Operate Responsibly

Remember … To start a cold engine, you may need to choke or prime it. However, don’t choke or prime the engine if it’s warm. You may flood the engine with too much fuel, making it difficult or impossible to start.